Imperial range and broiler repair in the Twin Cities
Imperial commercial range, oven, broiler and fryer repair on site in the Twin Cities: standing pilots, oven valves, thermostats, burners and cast iron.
Why will an Imperial range burner or oven not stay lit?
On an Imperial range the usual cause is a dirty or weak standing pilot, a clogged burner port, a weak thermocouple or a failing oven safety valve. Imperial ranges are built around simple mechanical controls. If an Imperial range smells of gas, leave the building and call the utility from the street.
About Imperial equipment
Imperial builds heavy, gas-fired cooking equipment: open-top ranges with cast-iron burners, griddle and hot-top sections, standard and convection ovens, broilers, fryers and the cheesemelters that sit over a line. In the Twin Cities that equipment shows up in independent restaurants, diners, bars, school and church kitchens and small hotels, where the range is the center of the line and has been for decades, often with several of the same make side by side.
These units are mostly mechanical. There is a pilot for every burner, a manual valve, a thermostat with a capillary bulb and a safety valve, and not much electronics. That makes them easy to keep running and also means the failures come from heat, grease and age rather than circuit boards. A tech who works on an Imperial spends time on pilots, burner ports, valves and the oven door, not on codes. We treat them as a standard commercial range job, including the oven side, and the pilot light problems guide covers the troubleshooting order. American Range is the nearest comparison.
Imperial open-top ranges
Equipment guide
Seen on this line: Standing pilot out or weak / Burner ports clogged with spill-over / Stiff, leaking manual valves
Imperial ranges use cast-iron open burners with a standing pilot, a venturi mixer and a manual valve for each. When a burner will not light or burns yellow, the cause is the pilot (clogged orifice, drifted flame), spilled food in the burner ports, or an air shutter that has moved. Valves get stiff and leak at the stem when grease bakes into them, and cast grates and burner heads crack from thermal shock. Hot-top and griddle sections have their own valves and thermostats. Pilot adjustment and valve work are gas work, so a technician does them, and cleaning the burner cap and ports is normal maintenance that keeps the flame blue and even.
Imperial standard and convection ovens
Equipment guide
Seen on this line: Thermostat out of calibration / Weak thermocouple or safety valve / Door sag, gasket wear and convection fan faults
A standard Imperial oven has a pilot, a thermostat with a bulb in the cavity and a safety valve that shuts the gas if the pilot or the thermocouple fails. The failures are a thermostat that runs hot or cold, a weak thermocouple that drops out under the pilot flame, a safety valve that clicks but does not hold, and oven doors that sag and leak heat. Convection ovens add a fan motor, a blower wheel and a door switch, and a motor that stops when the door switch is not made. Thermostat calibration, checked with a separate oven thermometer, is part of every visit because bakers and line cooks learn the oven's quirks and a drifted thermostat changes the whole line.
Imperial broilers and fryers
Equipment guide
Seen on this line: Clogged burner tubes and grease-soaked radiants / Fryer pilot, thermostat and high-limit faults / Infrared burner and salamander pilot faults
Imperial broilers use radiants or cast burners under grates, with the flare-ups, clogged burner tubes and grease-soaked radiants that any broiler suffers. Imperial fryers are tube-fired with a pilot, thermostat and high-limit, and the standing-pilot design is the most common source of calls. Cheesemelters and salamanders add infrared burners and a pilot per section. Grease is the enemy here: a broiler that is cleaned every night keeps working, and one that is not shows lifted flame, uneven heat and failing valves. Pilot flames get checked on every section during the visit.
Finding the model and serial plate
Imperial's rating plate is usually found inside the oven door frame, behind the front kick panel or on the inside of the front panel, and gives model, serial number and gas type. The model string codes the burner and griddle layout and the oven type, so read it in full. Note whether it is natural gas or propane.
Parts
Imperial parts are sold through the manufacturer and through foodservice parts distributors. Burner heads, valves, pilots, thermocouples and thermostats are widely available, and many are standard commercial designs. Orders go by model and serial number, and gas type matters for orifices and valves. Availability varies by model age, and we confirm the part number against the plate before anything is ordered.
Manufacturer warranty
If this equipment is still under the manufacturer's warranty, it should usually go through the manufacturer's authorized service network first. We are an independent company and not the manufacturer.
See also
Compared with
Guides
More cooking equipment brands
Imperial repair questions
Why does one burner on the range burn yellow and sooty?
Too little air at the mixer or a partly blocked port. The cleaning and adjustment are quick. Left alone, it leaves soot on pans, blackens the burner area and wastes gas. Do not adjust the mixer yourself on a lit burner.
The oven pilot is lit but the oven will not heat. Why?
The thermocouple may be too weak to hold the safety valve open, or the thermostat is not calling. Both are normal service items on this kind of oven, but they are gas work, so call a technician rather than adjusting the valve or bending the pilot bracket yourself.
Can cast-iron grates be repaired?
A cracked grate can be replaced as a part. If the cracks are in the burner head or the range top, we look at whether the section is worth rebuilding or whether the range itself has reached the end of its service life.
Why does the oven bake unevenly on one side?
Sagging doors or worn gaskets let heat escape on one side, and a thermostat bulb out of position reads wrong. A burner that is partly blocked can also do it. Check with an oven thermometer on each rack before blaming the food.
Do we need to shut the gas off when the range is down for repair?
Use the appliance shutoff if you know where it is. Never touch gas piping or the meter. If you smell gas, leave and call the gas utility from outside, and do not operate switches on the way out.
