Southbend range, convection oven and charbroiler repair in the Twin Cities
On-site Southbend range, convection oven and charbroiler repair across Minneapolis, St. Paul and the Twin Cities. A written price before work starts.
What fails most often on Southbend ranges and convection ovens?
On Southbend equipment the common failures are clogged burner ports and weak pilots on ranges and charbroilers, worn oven thermostats and door seals, and blower motors and door switches on convection ovens. Heavy cleaning is part of repair, because grease reaches the pilot and valve areas on this style of heavy-duty equipment.
About Southbend equipment
Southbend builds heavy-duty gas cooking equipment for restaurant lines, including ranges, convection ovens, charbroilers and griddles, aimed at kitchens that run the same station hard all day. It belongs to The Middleby Corporation, in the same group as Blodgett and Middleby Marshall. In the Twin Cities it is common on independent restaurant lines, hotel kitchens and some school and church kitchens, often in the form of a restaurant range with a standard oven or a bank of convection ovens.
Southbend work tends to be gas and mechanical rather than electronic. The Platinum and Ultimate lines are built with heavy burners and cast-iron tops, and the convection ovens, including the SilverStar and Marathoner styles, use a blower and a gas ignition system. Most calls start as a commercial range or a commercial oven that will not heat evenly, and a lot of the fix is cleaning and adjusting the parts that carry the flame.
Southbend restaurant ranges: Ultimate and Platinum
Equipment guide
Seen on this line: Open burner weak, uneven or hard to light / Oven pilot loses flame or safety valve drops out / Oven thermostat off from the dial setting / Door hinges and seals worn
Southbend ranges are heavy cast-iron units with open burners, griddle or hot tops, and a standard or convection oven below. Calls start with burner and pilot trouble: ports clogged by boil-over, pilot orifices blocked, and open burners that light poorly or burn yellow. The oven side has a thermostat, a safety valve and pilot, and the common failure is an oven that cannot hold the dial temperature or loses its pilot. Heavy use shows up as warped oven bottoms, worn door hinges and cracked grates. On a Southbend, a gas smell is a reason to walk out and call the utility.
Southbend convection ovens: SilverStar and Marathoner
Equipment guide
Seen on this line: Blower motor loud, slow or seized / Ignition fails or flame drops out / One side bakes darker than the other / Thermostat off or door switch sticking
Southbend's gas convection ovens use a two-speed blower motor, a door switch, a thermostat and an ignition control or pilot safety. The usual failures are the blower motor and wheel, the door switch, the thermostat and the ignition control. A blower that is loud or slow is a motor or a loose wheel. If the oven heats, then gives up, look at flame sensing. If the oven bakes one side darker than the other, the cause is usually airflow: the wheel, the baffles or a leaking door seal. Bakeries, church kitchens and cafeterias that load racks heavily should keep vents clear.
Southbend charbroilers
Equipment guide
Seen on this line: Burner section will not light / Radiants cracked or burned through / Flare-ups from grease build-up / Valve or pilot assembly fouled
Southbend charbroilers use gas burners under radiants or grates, with a pilot or igniter and a gas valve per section. Drippings and grease are the main enemy. Burners clog, radiants break down and flare-ups start in the grease tray. A section that does not light or burns weakly has a plugged burner or a bad pilot. Burned-out or cracked radiants cause uneven heat. We clean, replace radiants and valves, and check the flame. Cleaning the grease tray often prevents most of these calls, and so does lifting the radiants out for a proper scrape instead of brushing the top only.
Finding the model and serial plate
Southbend equipment has a rating plate with the model number, serial number, gas type and input or electrical rating. On ranges it is normally inside the front frame or behind the kick panel; on convection ovens it is on the side or the control panel. Have the model, serial number and gas type ready, and describe what failed. Southbend's older units may have a worn plate, so a photo of the frame helps.
Parts
Southbend parts such as pilot assemblies, thermostats, gas valves, blower motors and door switches come through the manufacturer's parts channel, and some commodity parts have compatible versions. Ignition controls and valves should match the model and fuel. Older units can have discontinued components, which can lengthen the search. We confirm the model and serial number before ordering parts.
Manufacturer warranty
If this equipment is still under the manufacturer's warranty, it should usually go through the manufacturer's authorized service network first. We are an independent company and not the manufacturer.
See also
Southbend repair questions
Why do the burners on my Southbend range light unevenly?
Uneven lighting is typically a clogged port or a pilot flame that is too small to cross-light all burners. Boil-over and grease get into the burner ports. A technician cleans the ports and checks the pilot and gas pressure before replacing parts.
My Southbend convection oven bakes one side darker. What should I check?
Check that the racks are not overloaded and the vents are clear. If that is fine, the cause is usually the blower wheel, a bent baffle, a worn door gasket or a thermostat that has drifted. A technician can confirm airflow and the door seal.
How often should I clean a Southbend charbroiler?
Clean the grease tray every day and the burner and radiant area on a regular schedule. Grease that builds up causes flare-ups and plugs burners. A neglected charbroiler is the single most common cause of repair calls on this equipment.
Is a used Southbend range worth buying and repairing?
It can be. The heavy construction ages well, but check the oven bottom, grates and valve stems before you buy. A used range that needs several parts may cost more to fix than the price suggests.
Why does the pilot on my Southbend oven keep going out?
The thermocouple may be weak, the pilot orifice may be dirty, or a draft may blow it out. Do not keep relighting it. A technician tests the thermocouple output and cleans the pilot. If you smell gas, leave and call the utility from outside.
